Harvest homework
Walking tractor is mainly equipped with harvester, the main reason for unit deviation: the cutting direction of harvester cutter clearance adjustment is different. The cutting resistance is different: one side of the cutter is high and the other side is low, and the cutting stubble height is different when harvesting, and the operating resistance is different. Improper cutting width selection; The ground is uneven. Corresponding measures should be taken according to the specific reasons.
Trenching work
The main reasons for the poor straightness of ditching operation: the deviation between the symmetrical center line of the cutter head plane and the center plane of the driving wheel shaft of the walking tractor exceeds the provisions: the cutter head is distorted and deformed, and the frame is distorted. Plough cutter installation error, plough cutter fracture, fall off, etc. Attention should be paid to check and correct the cutter head and rack. Install the rotary plough cutter correctly, adjust the position of the cutter head carefully, if the plough cutter breaks or falls off, stop and flutter immediately. Replace parts.
Irrigation and threshing
Equipped with the corresponding water pump and thresher, diesel engine flywheel belt connected with water pump or thresher, depending on the diesel engine flywheel rotation driven water pump or thresher can be used for irrigation and wheat and other crops threshing.